POWERSYS RECLOSER, Manual

Page: 35 / 87

- 29 -
CT Ratio Set CT ratio
NCT Ratio Set NCT ratio
Avg Interval Set average value process interval
Select FI Reset Set FI reset way(Auto / Manual)
Display Voltage
Selection of line to phase voltage and
line to line voltage
Phase Position Select phase position
Phase Rotation
Select whether phase rotation is ABC
or ACB
Source Side
Select which side will be power
source between ABC side and RST
side
Energy log duty Set duty time for energy logging
Closing delay Set delay time to close CB
Check V for FI
Select whether to consider voltage
when FI set
Reclaim T for FI Set reclaim time for FI clear
Important Key Delay
Set Delay about Important Key(ALT
SET, CLOSE, OPEN)
V Sensor Fail Delay Set delay time for Voltage Sensor Fail
I Cut Level Set level for current cutting
V Cut Level Set level for voltage cutting
Save Config Save analog configuration setting
DI
Debou
nce
Time
DI1~ DI10 Set DI1~10 debounce time
Save Config Set save DI debounce Configuration
DO
Pulse
Width
DO1~DO6 Set DO1~DO6 pulse width
Save Config Save DO pulse width setting
Backup
Set/Cle
ar
Set Switch Cnt Set number of switch operation
Clear Event Clear event information
Clear Fault Clear fault information
Clear Oper Count Clear operation information
Analog
Gain
Adj
Ia~In, Va~Vt Adjust analog gain
Save Config Save analog gain config setting
Clear Gain Data Clear analog gain config setting
Wavefo
rm
Sample Rate
Set sample rate when capturing
waveform
Record Size Set record size of waveform
Pre Cycle Set pre cycle number of waveform
Post Cycle Set post cycle number of waveform
Save Config Save waveform config setting