PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 74
6. Measure from the from to the scrub deck, it should
be 8 1/2”(ref) for an 82 models or 9 1/4”(ref) for a 90
models. Make sure the measurement is the same
on both sides.
7. Align the holes in the lift arms with the hole in the
scrub deck on both sides. Adjust by rotating the lift
arm to move in or out on the rod end.
8. Attach the lift arm to the scrub deck on both sides
using the screws, washers and lock nuts.
9. Tighten the lock nut securing the rod ends to the lift
arms, both sides.
10. Close scrub doors and turn scrub deck on, shut
scrub deck off and raise the scrub deck.
11. Move the unit far enough to look at pattern created
on the floor, it should have three uniform circles.
12. If not readjust scrub deck. If pattern is ok, open
scrub doors and reinstall squeegee blades and hitch
pins on both sides.
13. Close scrub doors.
PREVENTATIVE MAINTENANCE
8 1/2”(REF)
OR
9 1/4”(REF)
CORRECT BRUSH PATTERN
INCORRECT BRUSH PATTERN
INCORRECT BRUSH PATTERN
