PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 40
USING THE ROTARY TRASH RELOCATOR (RTR™)
1. Use the directional control pedal to stop the machine
on a level surface.
2. Move the throttle to the IDLE position.
NOTE: As you complete Steps three and four,
observe the two red lights labeled 1 and 2
in the upper left corner of the control pane.
• Light 1 illuminates when the hopper reaches the
minimum height required to use the RTR™ feature.
• Light 2 illuminates when the hopper reaches the
rotation stop point.
3. Pull back Lever 1 (press and hold the unlock hopper
button if equipped) to the RAISE position and hold
until Light 1 illuminates, then release.
WARNING
Make sure no one is in the area under or around
the hopper.
4. Pull back Lever 2 to the DUMP position (press and
hold the unlock hopper button if equipped) and hold
until Light 2 illuminates, then release.
NOTE: This rotates the hopper, causing the debris
to move from the rear entrance to the front
wall of the hopper. Rotating beyond this
point will cause the debris to be dumped
from the hopper.
5. Push Lever 2 forward (press and hold the unlock
hopper button if equipped) to the RETURN position
until the hopper rotates back and stops.
6. Push Lever 1 forward (press and hold the unlock
hopper button if equipped) to the LOWER position
until the hopper returns to the normal operating
position.
7. Move the throttle to the RUN position and resume
sweeping.
MACHINE OPERATION
