PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 80
Flap Replacement
Flaps located at the entrance lip of the hopper must be
replaced when worn or damaged. The flap panels may be
replaced separately.
1. Park the machine on a level surface and engage the
parking brake.
2. Raise the hopper.
3. Turn off the engine
4. Remove the flap retaining angle and worn or
damaged flaps.
5. Install new flaps.
6. Replace the retaining angle.
Frame Seal Replacement
Front Frame Seal
The hopper frame seal bolts to the front edge of the engine
pan. Install a new seal by folding it in half to align the holes.
Doubled edge with holes goes on the bottom. Support the
seal straight up while bolting the retainer bar in place. The
seal should fall over the retainer bar after installation. Be
certain that the seal edges are aligned to prevent twisting of
the seal.
Side Frame Seal
The side frame seals should clear the floor by at least ⅛”
(3.18 cm). If the bottom of a side seal measures ½” (1.27
cm) or more above the floor, readjust it or replace it by
removing the bolts on the inside of the wheel wells, installing
a new seal, and securing it with the bolts. The double edge
with the holes goes toward the front.
PREVENTATIVE MAINTENANCE
