Commander T Series PB# 4100032
Rev. C 03/12
PowerBoss, Inc. Copyright 2011
Page 25
MACHINE OPERATION
BASIC OPERATING CONTROLS AND
INDICATORS
Location of controls and indicators vary on engine type and
options purchase. Some of the controls and indicators may
not be on you unit.
IGNITION SWITCH
The three position key switch is used to turn the machine’s
power on and off. The ignition switch is located on the right
side of the instrument panel next to the horn.
HORN
The horn is activated by pressing the horn button located
on the right side of the instrument panel, next to the ignition
switch.
LIGHT SWITCH
The light switch is located in the upper right of the control
panel above the steering wheel. The light switch turns on and
off the lights.
MACHINE OPERATION
HOUR METER
The hour meter records the number of hours the machine has
been operated, providing a helpful guide for performing routine
maintenance tasks.
ENGINE COOLANT TEMPERATURE GAUGE
The engine coolant temperature gauge registers the
temperature of the engine coolant. Temperatures above 220°F
indicate an overheating engine.
ENGINE OIL PRESSURE
The engine oil pressure gauge ranges from 0 psi to 60 psi. A
reading below 7 psi indicates problems which may result in
damage to the engine.
VOLTMETER AMP GAUGE
A battery gauge is used on LP & Gasoline units. It indicates
the voltage being sent to the battery by the alternator. 13.5v is
normal. An Amp. Gauge is used on diesel units, It indicates a
charge or discharge of current to the battery.
FUEL LEVEL GAUGE
The fuel gauge indicates the amount of fuel remaining in the
tank for gasoline & diesel units.