Commander T Series PB# 4100032
Rev.C 03/12
PowerBoss, Inc. Copyright 2011
Page 67
Main Broom Taper Adjustment
NOTE: It is not usually necessary to perform this
adjustment. However, if the main broom
adjustment test shows a pattern that is
tapered in length (one end is wider than
the other), perform the procedures which
follow.
1. Locate the hex-shaped adjustment bar on the left
rear wall of the broom chamber underneath the
machine.
2. Loosen the retaining bolt on the right side of the hex
bar.
3. Grasp the hex bar with a wrench and rotate it
to raise or lower the left end of the main broom.
(The right end of the broom remains fixed. All
adjustments affect the left end of the broom.)
4. After adjustment, re-tighten the bolt.
5. Repeat the main broom adjustment test to see that
the broom is properly adjusted.
PREVENTATIVE MAINTENANCE
Correct Taper Pattern
Incorrect Taper Pattern
