PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 36
MACHINE OPERATION
STARTING
Gasoline or LP Power Units
WARNING
Before starting the engine, sit in the operator’s
seat and make sure the parking brake is locked.
1. Make sure the directional control pedal is in the
neutral position.
2. Make sure the throttle is in the idle position.
3. Turn the ignition key to the start position (to the
right). When the engine starts, release the key.
CAUTION
If the engine fails to start, do not continue
cranking for more than ten seconds. Allow the
starter motor to cool between attempts.
4. Release the parking brake.
OPERATING PROCEDURES
PRE-OPERATION CHECKS
Prior to starting the engine, check the following:
1. Engine oil level
2. Engine coolant level
3. Fuel level
4. Hydraulic fluid level
5. Brakes, steering and directional controls
6. The floor beneath the machine for signs of fluid leaks
Fluid levels should be correct. Brakes, steering and
directional controls should be functioning properly. Hoses,
lines and tanks should be free of damage and leaks.
