Commander T Series PB# 4100032
Rev.C 03/12
PowerBoss, Inc. Copyright 2011
Page 71
Side Broom Lift Cable Adjustment
This adjustment is made at the cable clevis attached to
the side broom assembly. It controls the height of the side
broom in the RAISED position. This adjustment must be
made with the hopper fully lowered.
1. Pull the side broom lever into the RAISED position.
2. Loosen the locknut on the threaded rod at the
clevis.
3. Turn the threaded rod in or out to set the side broom
in the maximum raised position.
4. Secure the cable adjustment by tightening the
locknut.
PREVENTATIVE MAINTENANCE
Side Broom Replacement
NOTE: Broom should be replaced if bristles worn
to a length of 3 inches; 7.62 cm or less.
NOTE: The side broom features a quick release
mechanism which enables the operator to
remove the brush in seconds.
1. Raise the side broom and lock in the RAISE
position.
2. Turn the side broom by hand until the brush retainer
bar is accessible.
3. Lift the bar and turn the broom clockwise (about
one eighth of a turn) until the lock pins in the broom
disengage from the drive plate.
4. Install the new broom by positioning the three drive
pins into the pilot holes of the drive plate.
5. Lift and rotate the broom until the broom retainer bar
springs into the locked position.
6. Check to make sure all thee drive pins are properly
engaged.
