PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 46
Pushing the Machine
Push the machine from the front or rear using the bum-
pers only.
NOTE: The propulsion pump is equipped with a
tow valve located on the top of the pump.
To engage the tow valve:
1. Turn the flat-sided shaft at the top of the pump 90°.
2. Valve must be returned to its original position for
normal operation the machine.
ATTENTION!
Do not tow or push the machine a distance of
more than .5 miles (.80 kilometers) or faster than
one mile per hour (1.61 km). Exceeding these
restrictions may cause damage to the hydraulic
system. If towing will exceed the above
restrictions, the rear wheel must be raised or
supported by a dolly.
MACHINE OPERATION
BLOWER (OPTION)
The blower can move debris from hard-to-reach areas into
he path of the sweeper using forced air. To operate; With
unit running @ high Rpm’s and impeller on, take the wand
in hand and pull the blower control knob out. Aim at desired
debris. Return wand and knob to normal position when
done.
TRANSPORTING THE MACHINE
Using a Trailer or Transport Vehicle
1. Position the machine on the transport vehicle or
trailer and apply the parking brake.
2. Chain the machine down using the two (2) tie-down
holes in the frame in front of both front wheels and
one (1) @ the rear center of the frame extension
bumper.
NOTE: Attach Tie Downs To The Frame &
Extension Bumper Only!
