Commander T Series PB# 4100032
Rev.C 03/12
PowerBoss, Inc. Copyright 2011
Page 77
Main Squeegee Tool Removal
All machines are equipped with auto-squeegee lift. To
remove the squeegee tool, proceed as follows:
1. Engage the parking brake and chock the wheels.
2. Lower squeegee & pull the pin at the rear of the
squeegee tool.
3. Remove the knobs at the square lift arms supports.
4. Disconnect the vacuum hose from the squeegee.
5. Lift the supports up off the pins on the squeegee
frames and slide the squeegee away from the
machine.
Main Squeegee Tool Installation
1. At the back of the machine, push the squeegee
under the machine into position.
2. Attach the lift arms to the supports onto the pins on
the squeegee frame.
3. On each side of the squeegee, attach the hand
knobs (one on each side) to the squeegee frame
supports.
4. Connect the quick-release pin to the squeegee.
5. Connect the vacuum hose to the squeegee.
PREVENTATIVE MAINTENANCE
Inner Squeegee Replacement
The inner squeegee is a component of the rear squeegee
assembly. When the squeegee is down, locked and the rear
squeegee blade is flared, check to see if the inner squeegee
has become too worn to make proper even contact with the
floor.
1. Remove the main squeegee tool (see removal
instructions).
2. Remove the nuts on the front of the inner squeegee
frame.
3. Remove the strap and the inner squeegee rubber.
4. Install the new inner squeegee rubber.
5. Position the strap and secure with the nuts.
Auto Squeegee Lift Mechanism
Bearing Replacement: If any binding occurs in the lift
apparatus, replace the bushings, spacers and fiber
glide bearings located on the squeegee lift assembly as
necessary.
NOTE: Bent components may cause binding.