PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 42
SCRUBBING
Operating the Scrub Brushes
1. Activate the scrub brushes by putting the broom
control lever in the ON position.
2. Lower the scrubhead to the floor with the scrubhead
rocker switch located on the console left of the
operator. Press to “Lower” Position. Scrubhead is
raised by same switch. Press to “Raise” position.
NOTE: The scrubhead gauge is a visual indication
of the scrub deck position and not the
amount of pressure on the floor.
Starting Solution Flow
3. Push the solution lever forward until the desired
amount of solution is applied.
NOTE: This is a gravity feed system. Maximum
flow is 3 gpm.
4. Turn on the vacuum impeller, Push the impeller
lever forward to the on position.
Lower The Squeegee
5. Press the squeegee switch to the Lower Position.
6. Drive the machine over the area to be scrubbed.
MACHINE OPERATION
