Planmeca Sovereign Classic, User Manual

Page: 135 / 298

Hands-free with sensor
Once the operation light is lit, keep your hand longer in front of the sensor to
adjust the intensity of the light.
NOTE
If the operating light is installed to another manufacturer’s dental unit, the
intensity adjustment can be done only from the operating light.
From dental unit
The light intensity is displayed on the Operating light button. When you
change the intensity, the information on the button changes accordingly.
Control panel: Press and hold the Operating light button to adjust the
operating light intensity.
Foot control: The foot control can be programmed so that you can adjust the
operating light intensity from the foot control. For programming instructions,
see section "Foot control functions" on page 200.
After one second, the intensity will increase until you release the button/
knob. When you press and hold the button/knob again, the intensity will start
to decrease.
23.6.6 Adjusting intensity of operating light in composite mode
The intensity adjustment range is from 30% to 100%.
Each time you adjust the intensity, the direction of the adjustment (increase/
decrease) changes. Thus, if you first increase the intensity, the intensity will
be decreased the next time you adjust it.
You will hear short successive clicking sounds while the intensity is being
adjusted and a long signal tone when the maximum/minimum intensity is
reached.
The operating light intensity can also be programmed, see section
"Planmeca Solanna and Planmeca Solanna Vision operating lights" on page
191.
23 Operating dental unit
User's manual Planmeca Sovereign Classic 125