Planmeca Sovereign Classic, User Manual

Page: 240 / 298

29.9.6 Starting waterline cleaning cycle
About this task
WARNING
Even though every effort has been taken to ensure patient safety, even in
case of malfunction or misuse, always make sure that the unit is properly
flushed before taking it into use. For instructions on how to flush the
waterlines, see section "Suction cleaning" on page 223.
CAUTION
Only Planmeca PlanClear disinfectant must be used. Planmeca does not
guarantee the suitability of and is not liable for damages caused by other
disinfectants.
CAUTION
The flushing cycle is performed using domestic water, which might reduce
the effect of Planmeca PlanClear, if the domestic water is not clean.
CAUTION
Ensure that the suction hoses are NOT in the suction tube cleaning holder
when you perform waterline cleaning.
NOTE
Adjust the water flow of the cup fill tube so that the water does not splash
into the bowl.
NOTE
The duration of waterline cleaning is < 10 minutes in the e an affect
time of min. 8 hours + < 30 minutes in the morning.
NOTE
The flushing cycle can be interrupted by pressing Cancel on the Cleaning
tab. After the interruption, you must flush the waterlines before the dental
unit can be used normally.
NOTE
Immediately remove any Planmeca PlanClear splashes from the dental unit.
Steps
1. Remove the cup from the cup holder. Turn the cup fill tube so that it is
above the bowl and not above the cup holder.
2. Press Maintenance to go into maintenance mode.
29 Flushing and cleaning programs
230 Planmeca Sovereign Classic User's manual