95
09
Additional Materials
English
Additional Materials 09
In the event errors appear in main unit display
In the event of a hardware error, the DVD-V8000 will display an error code and the name of the error.
Errors may also occur with non-hardware matters, due to disc scratches or soiling, or in the case of R/RW media, due to poor
recording quality. The following are the main non-hardware-related errors that may occur.
However, note that these are not all the possible errors, so in the event an error appears in the main unit’s display, check to be
sure that the disc is not scratched or soiled.
Other related
Symptom
Can’t control with RS-232C.
Can’t use external sync.
When setup menu is displayed, it disappears
after a few seconds.
Mouse doesn’t operate.
No sound.
Internal clock displays wrong time.
Cause/Remedy
Check the
ADV. SETUP
menu’s serial port assignment, Baud rate setting,
and serial interface specifications.
Go to the
ADV. SETUP
menu and confirm that the [
EXTERNAL SYNC
]
setting is [
ON
]. Also, consult the “Important” item regarding the external
sync function on page 80.
Periodic resets may occur if the DVI connection has become unstable. Check
and confirm that the DVI connection is secure. Also, this kind of symptom
may occur if the input for a DVI-connected display is set to something other
than DVI. When not using DVI output, disconnect the DVI connections.
In general, commercially marketed USB mouse devices are manufactured
to common specifications and can be used with the DVD-V8000, but oper-
ating compatibility has not been confirmed for all devices available on the
market, with the result that it is possible some such devices may not be
compatible with the DVD-V8000.
Digital audio is not output unless [
Digital Audio Out
] is set to “
ON
” in the
Initial Settings section (page 40). Also, analog audio is not output if DTS
audio has been selected.
The internal clock has an permissible operating deviation of about 2 min-
utes per month. In addition, if the power cord is disconnected for more
than about 7 to 10 days, the internal clock’s time will be cleared and must
be reset when the power is restored (page 78).
Error Code: 1B
Index 0 Error
Error Code: 1C
Wobble Detect
Error Code: 33
Focus Error
Error Code: 38
Disc Sense
Error Code: 72
SUBQ Read Error
Error Code: 73
ID Read Error
Error Code: 74
SUBQ Read Error
Error Code: 81
TOC Read Error
Error Code: F8
Loading Error
USB OVER CURRENT DISABLE ALL PORT
Errors that may occur due to disc scratches or soiling, or in the case of R/
RW discs, due to poor recording quality.
Occurs when disc tray is blocked when attempting to open or close. Check
to be sure disc is not impeded.
This error appears when the total current of the connected USB devices
exceeds the unit’s permissible value (Max. 0.7 A).
Remove the connected USB memory device and reconnect the main unit’s
power cord.
This error may also appear in the event of an error in the USB device itself.
