61
Advanced Setup Menu (Settings for Commercial Use) 06
06
Advanced Setup Menu (Settings for Commercial Use)
English
5. Setting KEY LOCK
5.1. How to set KEY LOCK
When [
KEY LOCK
] is set to [
ON
] and the
ENTER
button is
pressed, the following menu will appear. Using the cursor
up/down buttons (
»
,
«
), select [
1. TRAY
], [
2. REMOTE CON-
TROL
], [
3. FRONT KEY
], and then use the cursor left/right
buttons (
|
,
\
) to set to either [
Disable
] or [
Enable
].
When this is done, the main unit’s display will appear as
shown below.
∆
cursor
|
,
\
buttons
1. TRAY
When set to [
Disable
], the tray cannot be opened by
¶
The main unit’s
STOP OPEN/CLOSE
button
¶
The RS-232C’s
OP
,
RJ
commands
¶
The
EXTEND TERMINAL
’s
OPEN/CLOSE
command.
2. REMOTE CONTROL
When set to [
Disable
], commands from the remote control
unit cannot be input.
3. FRONT KEY
When set to [
Disable
], commands from the main unit's front
panel buttons cannot be input.
Example 1
TRAY: Disable
REMOTE CONTROL: Disable
FRONT KEY: Enable
With these settings, the remote control unit is disabled, but
commands can be input through the main unit’s front panel
buttons, but the tray cannot be opened by using the
STOP
OPEN/CLOSE
button.
Example 2
TRAY: Enable
REMOTE CONTROL: Disable
FRONT KEY: Disable
With these settings, the remote control unit and front panel
buttons are disabled. [
TRAY
] is [
Enable
], but since commands
are not accepted from the remote control unit and front panel
buttons, they cannot be used to open the tray. However, the
RS-232C’s
OP
command can be used to open the tray.
Note
KEY LOCK can be set by using either the remote control unit
or the mouse.
¶
When the mouse cursor (hand pointer ) appears over
an item, clicking the left mouse button selects the item.
¶
When an item is selected, clicking the right or left mouse
buttons allows the item’s values to be changed.
5.2. KEY LOCK Indicator display table
The indicator displays for each KEY LOCK setting value are as follows:
KEY LOCK indicator display
Off
Off
Flashes about 2 seconds when remote control unit’s OPEN/CLOSE button is
pressed, or if the main unit’s STOP OPEN/CLOSE button is pressed during stop
mode.
Lights
Flashes about 2 seconds when remote control unit buttons are pressed.
Lights
Flashes about 2 seconds when remote control unit buttons are pressed, or if
the main unit’s STOP OPEN/CLOSE button is pressed during stop mode.
Lights
Flashes about 2 seconds when main unit’s buttons are pressed.
Lights
Flashes about 2 seconds when main unit’s buttons are pressed, or if remote
control unit’s OPEN/CLOSE button is pressed.
Lights
Flashes about 2 seconds when buttons on remote control unit or main unit are
pressed.
Lights
Flashes about 2 seconds when buttons on remote control unit or main unit are
pressed.
TRAY
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Disable
REMOTE
CONTROL
Enable
Enable
Disable
Disable
Enable
Enable
Disable
Disable
FRONT
KEY
Enable
Enable
Enable
Enable
Disable
Disable
Disable
Disable