Pioneer SC-LX71, Operating Instructions Manual

Page: 45 / 134

The Advanced MCACC menu
07
45
En
fo r seve r al seating p ositions in you r listening a r ea.
1
Place the mic r o p hone at the r efe r ence p oint
indicated on-sc r een and note the last microphone
placement will be at your main listening position:
3 Connect the microphone to the MCACC SETUP MIC
jack on the front panel.
Make su r e the r e a r e no obstacles between the s p eake r s
and the mic r o p hone.
If you have a t r i p od, use it to p lace the mic r o p hone so that
it’s about ea r level at you r no r mal listening p osition.
Othe r wise, p lace the mic r o p hone at ea r level using a
table o r a chai r .
4 When you’re finished settings the options, select
START then press ENTER.
5 Follow the instructions on-screen.
• Make su r e the mic r o p hone is connected.
• If you’ r e using a subwoofe r , it is automatically
detected eve r y time you switch on the system. Make
su r e it is on and the volume is tu r ned u p .
• See
Problems when using the Auto MCACC Setup
on
p age 10 fo r notes r ega r ding high backg r ound noise
levels and othe r p ossible inte r fe r ence.
6 Wait for the Auto MCACC Setup to finish
outputting test tones.
A pr og r ess r e p o r t is dis p layed on-sc r een while the
r eceive r out p uts test tones to dete r mine the s p eake r s
pr esent in you r setu p . T r y to be as quiet as p ossible while
it’s doing this.
• Do not adjust the volume du r ing the test tones. This
may r esult in inco rr ect s p eake r settings.
• With e rr o r messages (such as
Too much ambient
noise! o r Check microphone ) select RETRY afte r
checking fo r ambient noise (see
Problems when
using the Auto MCACC Setup
on p age 10) and
ve r ifying the mic connection. If the r e doesn’t seem to
be a pr oblem, you can sim p ly select GO NEXT and
continue.
7 If necessary, confirm the speaker configuration in
the OSD.
2
The configu r ation shown on-sc r een should r eflect the
actual s p eake r s you have.
If no o p e r ations a r e p e r fo r med fo r 10 seconds while the
s p eake r configu r ation check sc r een is being dis p layed,
the Auto MCACC Setu p will r esume automatically. In this
case, you don’t need to select ‘ OK ’ and pr ess ENTER in
ste p 8.
If you see an e rr o r message ( ERR ) in the r ight side
column (o r the s p eake r configu r ation dis p layed isn’t
co rr ect), the r e may be a pr oblem with the s p eake r
connection. If selecting RETRY doesn’t wo r k, tu r n off the
p owe r and check the s p eake r connections. If the r e
doesn’t seem to be a pr oblem, you can sim p ly use
/
to select the s p eake r and
/
to change the setting
(and numbe r fo r su rr ound back) and continue.
8 Make sure ‘OK’ is selected, then press ENTER.
A pr og r ess r e p o r t is dis p layed on-sc r een while the
r eceive r out p uts mo r e test tones to dete r mine the
o p timum r eceive r settings fo r channel level, s p eake r
distance, and Acoustic Calib r ation EQ.
Again, t r y to be as quiet as p ossible while this is
ha pp ening. It may take 3 to 7 minutes.
• If you selected a Stand.Wave Multi-Point setu p (in
ste p 2), you will be asked to p lace the mic at the 2nd
and 3 r d r efe r ence p oints befo r e finally p lacing it at
you r main listening p osition.
Note
1 Switch the Multi-Point setting NO if you only use one listening p osition.
1 2
3
2nd r efe r ence
p oint
3 r d r efe r ence
p oint
Main listening
p osition
VIDEO3 INPUT
DIGITAL IN S-VIDEO VIDEO L R AUDIO PHONES
SPEAKERS CONTROL
MULTI-ZONE
& SOURCE
ON/OFF
MCACC
SETUP MIC
PARAMETER
ENTER
(TUNE)
(TUNE)
(ST) (ST)
AUDIO VIDEO
TUNER EDIT
iPod DIRECT
USB
AUTO SURR/
STREAM DIRECT
HOME
THX
STANDARD
SURROUND ADVANCED
SURROUND STEREO/
A.L.C. BAND
HOME MENU RETURN
MCACC
SETUP MIC
2 This sc r een is only shown if you selected ALL o r Speaker Setting f r om the Auto MCACC menu.
Now Analyzing... 2/10
Environment Check
1b.Auto MCACC
A/V RECEIVER
Exit Cancel
Ambient Noise : OK
Microphone :
Speaker YES/NO
:
L : YES
R : YES
C : YES
1b.Auto MCACC
SR : YES
SBR :
YES
SBL : YES
SL : YES
SW :
YES
10
OK RETRY
A/V RECEIVER
Exit Cancel
Now Analyzing...
1b.Auto MCACC
A/V RECEIVER
Exit Cancel
Subwoofer Check :
Now Analyzing... 5/10
Surround Analysis
1b.Auto MCACC
A/V RECEIVER
Exit Cancel
Speaker System : OK
Channel Level :
Speaker Distance :
Standing Wave
:
Reverb :
Aco Cal EQ Pro.
:
SCLX81_71.book 45 ページ ２００８年７月２５日 金曜日 午後３時１分