66
Tilt Mount Unit: PDK-5011
4.6.3 Assembling the mounting hardware and mounting the plasma display
Special screws (M6)
2
Remove the hardware on the wall side and the hard-
ware on the PDP side.
For the PDK-5011
3
Attach the PDP side hardware to the plasma display.
Notes
• Place a sheet or protective cover to protect the
display from scratches or damage.
• Be sure to attach it on top of a flat table or similar
surface.
4
Fix the plasma display to the PDP side hardware with
bolt M8 (6 locations).
Usually, use the holes marked with the red triangle
"
%
".
If the 42-inch model is installed with an inclination of
18° or more, the top part of the screw used to adjust
the angle may be visible from a horizontal position in
front of the screen. In this case, you can hide the top
of the screw by using the holes without a red triangle
mark "
%
".
Wall side hardware
PDP side hardware
PDP side hardware
Top side of plasma display
1
Remove the special screws (2 locations) from the bot-
tom of the hung on wall unit.
Top side of plasma display
Note
Be sure to install the speaker at this stage.
For the installation method, refer to the speaker
instruction manual.
For the PDK-WT02
3
Attach the PDP side hardware to the plasma display.
Notes
• Cover the display with a sheet or similar protective
material to protect it from scratches or other damage.
• Be sure to attach it on top of a flat table or similar
surface.
1
Place the spacers (4 locations).
Place the spacers as shown in the figure below.
Note
Place them so that the holes in the spacers are aligned
with the holes in the plasma display.
Spacer
