113
Menu Mode
2) Power Management and Auto Power OFF Setting
When no video signal (synchronizing signal) is detected, this function automatically sets the energy saving state in
order to save power.
• To not use the energy saving function, set to [OFF/DISABLE].
• To set the power standby state when the input signal is not detected within 8 minutes, set ‘AUTO POWER OFF’
to [ENABLE].
• To switch between the normal-operation state and the energy saving state depending on whether or not there is
an input signal, set ‘POWER MANAGEMENT’ to [ON].
Settable condition : Power management: INPUT1, INPUT2 (PC signal), INPUT5
★
(Applicable only when the
PDA-5003 is mounted.)
Auto power OFF: Conditions other than those above
Factory setting
: OFF/DISABLE
Notes
• To return from the power standby state to the normal operation state, press the power button on the remote
control or the main control panel.
• To return from the energy saving state by power management to the normal operation state, operate the personal
computer or press the [INPUT] button on the remote control or main-control panel.
However, during G ON SYNC or composite SYNC input operation does not return by simply operating the personal
computer. After operating the personal computer, press the [INPUT] button.
• The power consumption during power standby.
PDP-425CMX: 1.2 W
PDP-42MXE10: 1.5 W
• The power consumption during the energy saving state by power management is approximately 2 W.
M E N U
I N P U T 1
CHANGE
SET
EXIT
MENU
S C R E E N
S E T U P
O P T I O N
P O W E R M G T.
: O F F
S I G N A L F O R M AT
P I C T U R E
3
OFF/DISABLE
ON/ENABLE
2
1
Select ‘SETUP‘.
2
Place the cursor over ‘POWER MANAGEMENT (AUTO
POWER OFF)’ and change the setting with the [SET]
button.
Each time the [SET] button is pressed, the setting is
changed as shown below.
