172
RS-232C Adjustment
5.5 RS-232C Adjustment
This display has a RS-232C terminal. It is possible to use a PC to make various adjustments and settings.
5.5.1 About the RS-232C Adjustment
Adjustments in the RS-232C adjustment:
• The adjustments are written to the same memory area as for the integrator mode (refer to section 5.4.4, “PICTURE,
White Balance and SCREEN Position Adjustment Values Memory Area Tables (pg. 167)”).
(1)
Always assign an ID before using the RS-232C adjustment. Also, include the ID for the set to be
controlled or adjusted in the RS-232C command. For details, refer to section 5.5.2, “Interface (pg.
173)”.
(2) Of the adjustment values and setting items set by RS-232C commands, there are some items that are
stored in memory and some that are not. For details, refer to section 5.5.5, “List of RS-232C Commands
(pg. 177)”. Also, when storing values in last memory, the conditions described in section 5.1.5, “Last
Memory (pg. 107)”, must be satisfied.
(3) <OSDS00>/<OSDS01> (OSD display disable/enable setting)
Regardless of the setting, the following items can be displayed.
• Menu display (menu mode, integrator mode)
• Warnings before Auto Power OFF or Power Management operation
• Warning of high temperature inside the set
• Display announcing that the FUNCTIONAL LOCK is set, and the FUNCTIONAL LOCK setting display
• Display call (including holding a button down)
(4) When performing control using the RS-232C commands, not only control the input signal, but also be
sure to control the power. If the power is ON when there is no signal, the display continues to have a
weak discharge, which could affect the life of the display.
Notes
