Part I: PCM-049/phyCORE-OMAP44xx System on Module
phyCORE-OMAP44xx
12
©
PHYTEC Messtechnik GmbH
2012
L-760e_1
•
High-Speed USB OTG interface
•
High-Speed USB HOST interface provided by on-board USB transceiver
1
•
Full-Speed USB interface (USBC1) brought out to the phyCORE-Connector as additional USB-Host interface
1
•
10/100 MBit Ethernet interface with HP Auto MDIX support
1
•
Single supply voltage of 3.3 V (max. 900 mA)
•
All controller required supplies generated on board
•
On-board power management IC with integrated RTC
•
24-bit parallel LCD interface
•
HDMI interface
•
5 channel DSI LCD interface
•
Support of standard 20 pin debug interface through JTAG connector
•
Three I
2
C interfaces
•
One SPI interfaces
•
Two SD/MMC card interfaces with DMA
•
I
2
S interface
•
Multichannel audio serial interface (McASP)
•
Keyboard interface with up to 6 rows and 6 columns
•
Up to two LVDS camera interfaces
•
Two user programmable LEDs
•
Four dedicated GPIO/IRQ ports (additionally nearly all pins can be alternatively used as GPIOs)
•
Industrial temperature range (-40°C...+85°C)
1.
USBC1 is meant for USB Inter-Chip connectivity only. Please refer to the OMAP4430 Reference Manual for more information.
Caution:
Samtec connectors guarantee optimal connection and proper insertion of the phyCORE-OMAP44xx.
Please make sure that the phyCORE-OMAP44xx is fully plugged into the matting connectors of the carrier
board. Otherwise individual signals may have a bad, or no contact.
