Phytec phyCORE-OMAP44 Series, Hardware Manual

Page: 104 / 168

Part II: PCM-959/phyCORE-OMAP44xx Carrier Board phyCORE-OMAP44xx
92 ©
PHYTEC Messtechnik GmbH
2012
L-760e_1
JP7 Jumper JP7 selects the voltage level of the CAM-2_CTRL1
pin (X4-27) at phyCAM-Connector X4 Section 2.1.3.9.2
open CAM-2_CTRL1 not connected
1+2 CAM-2_CTRL1 connected to VCC_CAM-2
2+3 CAM2_CTRL1 connected to GND
JP8 Jumper JP8 selects the voltage level of the CAM-2_CTRL2
pin (X4-4) at phyCAM-Connector X4 Section 2.1.3.9.2
open CAM-2_CTRL2 not connected
1+2 CAM-2_CTRL2 connected to VCC_CAM-2
2+3 CAM2_CTRL2 connected to GND
JP9 Jumper JP9 forces the USB OTG interface of the phyCORE-
OMAP44xx to function either as host (master), or device
(slave). Section 2.1.3.6
open USB_OTG_ID floating, phyCORE-OMAP44xx in slave
mode, or according to the mode configured by software
closed USB_OTG_ID connected to GND, phyCORE-OMAP44xx in
host mode
JP11 Jumper JP11 enables the bus transceiver of the first
phyCAM-P camera interface Camera_1 at connector X20
For future
derivatives of
the phyCORE-
OMAP44xx !
open Bus transceiver disabled; first phyCAM-P interface
Camera_1 not available
closed Bus transceiver enabled; first phyCAM-P interface
Camera_1 can be used
JP12 Jumper JP12 selects either 8-bit, or 10-bit resolution of
the first phyCAM-P camera interface at connector X20
For future
derivatives of
the phyCORE-
OMAP44xx !
open First phyCAM-P interface with 8-bit resolution
closed First phyCAM-P interface with full 10-bit resolution
JP13 Jumper JP13 selects either the parallel, or the DSI display
interface of the phyCORE-OMAP44xx as source for the
PHYTEC Display -Interface (PDI) at connector X12 Section 2.1.3.7.1
open Data of the parallel display interface of the phyCORE-
OMAP44xx brought out at PDI-Connector X12
closed Data of the DSI interface of the phyCORE-OMAP44xx
brought out at PDI-Connector X12
Jumper Setting Description Chapter
Table 41: phyCORE-OMAP44xx Carrier Board Jumper Settings
1