Philips epiq 7, User Manual

Page: 261 / 318

2. Disconnect the transducer from the system, and remove any accessories attached to or
covering the transducer.
3. To remove all organic matter and other residue, use a pre-cleaner or detergent to assist in
removing protein residuals. Enzymatic cleaners must be diluted prior to use per the
manufacturer’s instructions for dilution. Enzymatic cleaners are generically approved for
use.
4. When cleaning the lens, use a blotting motion rather than a wiping motion.
5. To remove remaining particulate and cleaning residue, rinse thoroughly with water up to
the immersion point shown in “Disinfecting Non-TEE Transducers by Immersion” on page
268 and “Disinfecting TEE Transducers by Immersion” on page 270 .
6. Optional: Wipe with a dry cloth. To dry the lens, use a soft cloth and a blotting motion
instead of a wiping motion.
NOTE
If you use cleaning wipes, it may be unnecessary to rinse the transducer with water. Always
follow the product label recommendations.
Cleaning and Disinfecting Cables and Connectors
Before cleaning the cables and connectors, read the warnings and cautions in “Transducer,
Cable, and Connector Cleaning” on page 258 and “Transducer Care Safety” on page 255 .
The cables and connectors of all transducers can be disinfected using a recommended wipe or
spray disinfectant.
CAUTION
Do not bend or crimp the gastroscope or cable.
1. Disconnect the device from the system.
2. Push the connector cover, if available, onto the connector to protect against fluid splashing
onto the contacts.
3. Orient the device and the connector so they are both facing up (strain reliefs on the
bottom).
Transducer, Cable, and Connector Cleaning Transducer Care
EPIQ 7 User Manual 4535 617 25341 261