Safety – Setting up and commissioning – Operation – Spare parts lists
Positioning laser (optional)
36
2021-03-22
Important!
Before lowering the power units (milling cutter and sawing units), it is essential
to ensure that the workpiece is clamped and your hands are not in the lowering
path of the power units.
After finishing milling or sawing, switch off the power unit with the power unit switch
on the control panel (0 position) before lifting the unit.
Before lifting the power unit, the power
unit switch must be switched off at
the control panel. (On/Off switch
in “0” position)
26.2 Setting the lifting and lowering speeds of the power units
Slotted screws are located on the underside of the two pneumatic cylinders (on the hose connection);
you can use them to adjust the lifting and lowering speeds of the power units.
Important!
If you do change the lifting and lowering speeds, proceed carefully and check
the lifting/lowering speed of the power units after every minor adjustment.
The pressure is set correctly at the factory.
(T
oo high a speed (= high air pressure) can damage the mechanical system.)
27 Positioning laser (optional)
The positioning laser is used as an orientation aid for precise lowering of the milling and cutting tools.
The lasers are activated with the switch (1) above the main switch.
The two laser units for the cross-cut axis are mounted on the rear of the control cabinet and can be moved
by loosening the clamping screw to such an extent that the tool centre points can be adjusted for all
power units.
1