Pepperl+Fuchs Pulscon LTC57, Manual, Page: 51 / 176

Pulscon LTC57 PROFIBUS PA
Operating options
2015
-0
3
51
8.2 Structure and function of the operating menu
8.2.1 Structure of the operating menu
Menu Parameter/ submenu Meaning
Language parameter
a
a
In case of operation via operating tools (e. g. PACTware), the Language parameter is located at Setup

Advanced setup

Display.
Defines the operating language of the on-site
display.
Setup Parameter 1 ... Parameter N When all these parameters have been
assigned appropriate values, the measured
should be completely configured in a
standard application.
Advanced setup Contains further submenus and parameters:
• to adapt the device to special measuring
conditions.
• to process the measured value (scaling,
linearization).
• to configure the signal output.
Diagnostics Diagnostic list Contains up to 5 currently active error
messages.
Event logbook
b
b
Only available for operation via on-site display.
Contains the last 20 messages (which are no
longer active).
Device information Contains information needed to identify the
device.
Measured values Contains all current measured values.
Data logging Contains the history of the individual
measuring values.
Simulation Used to simulate measured values or output
values.
Device check Contains all parameters needed to check the
measurement capability of the device.
Expert .
c
Contains all parameters of the
device (including those which
are already contained in one
of the above submenus). This
menu is organized according
to the function blocks of the
device.
c
On entering the Expert menu, an access code is always requested. If a customer specific access code has not been defined, 0000
has to be entered.
System Contains all general device parameters
which do not affect the measurement or the
communication interface.
Sensor Contains all parameters needed to configure
the measurement.
Output • Contains all parameters needed to
configure the current output.
• Contains all parameters needed to
configure the switch output (PFS).
Communication Contains all parameters needed to configure
the digital communication interface.
Diagnostics Contains all parameters needed to detect
and analyze operational errors.
Table 8.2