![background image](http://html1.mh-extra.com/html/patton-electronics/smartware-r-3-20/smartware-r-3-20_software-configuration-manual_4044387439.webp)
Call router configuration task list
439
SmartWare Software Configuration Guide
33 • Call router configuration
Mode:
Context CS
Example:
Remove an entire mapping table
node(cfg)#context cs
node(ctx-cs)[switch]#no service HUNT-BRI
Activate the call router configuration
Prior to activate the call router configuration you can show the whole context CS configuration and the entire
call routing tables.
The call router configuration is activated as soon as the CS context comes out of shutdown (e.g. at boot time or
by manually entering command
no shutdown
). You can modify the configuration at runtime; changes will be
active after 3 seconds. SmartWare offers a number of possibilities to monitor and debug the CS context and
call router configurations. For more information refer to chapter 42,
“VoIP debugging”
on page 532.
Note
It is not necessary to shutdown the CS context prior to making any configu-
ration changes.
Procedure:
To show and activate the call router configuration
Mode:
Context CS
Note
Unlike previous versions of SmartWare you must explicitly enter the
no
shutdown
command to activate the call router.
Step
Command
Purpose
1
node(ctx-cs)[switch]#no service service-
name
Delete the service
service-name.
Note:
You do not have to enter the type of the service when
just deleting it. The type must only be specified when creating
a service.
Step
Command
Purpose
1
node(ctx-cs)[switch]#show call-router
config
Show the actual call router configuration. This displays all
routing and mapping tables in the current context CS. When
you are inside a routing or mapping table configuration
mode, only the current table is displayed.
2
node(ctx-cs)[switch]#show running-
config
Show the whole running config includes the call routing
tables
3
node(ctx-cs)[switch]#debug call-
router detail
level
Enable the call router debug monitor. Use level 1 for get
informed about errors and increase the level up to 5 to track
calls during route lookups.
4
node(ctx-cs)[switch]#no shutdown
Activate the whole CS context configuration including the call
router configuration.
5
node(ctx-cs)[switch]#show call-router
status
Show the actual call router status. This command can be used
to examine whether or not the call router accepted all routing
entries as entered in the configuration.