27
SmartWare Software Configuration Guide
About this guide
•
Chapter 3,
"Command line interface (CLI)"
on page 44 gives an overview of the CLI and the basic features
that allow you to navigate the CLI and edit commands effectively.
•
Chapter 4,
"Accessing the CLI"
on page 48 describes the procedures for entering SmartWare commands via
the command line interface (CLI), to obtain help, to change operator mode and to terminate a session.
•
Chapter 5,
"Establishing basic IP connectivity"
on page 68 explains how to establish network-based con-
nections to and from your SmartNode by using IP interfaces and Ethernet ports.
•
Chapter 5,
"System image handling"
on page 59 describes how to load and maintain system images and
driver software.
•
Chapter 6,
"Configuration file handling"
on page 69 describes how to upload and download configuration
files from and to a SmartNode.
•
Chapter 7,
"Basic system management"
on page 83 describes parameters that report basic system informa-
tion to the operator or administrator, and their configuration.
•
Chapter 8,
"RADIUS Client Configuration"
on page 94 provides an overview of the authentication, autho-
rization, and accounting (AAA) component in SmartWare and describes how to configure the RADIUS cli-
ent, a subpart of the AAA component.
•
Chapter 9,
"IP context overview"
on page 105 outlines SmartWare Internet protocol (IP) context, together
with its related components.
•
Chapter 10,
"IP interface configuration"
on page 111 provides a general overview of SmartNode interfaces
and describes the tasks involved in their configuration.
•
Chapter 11,
"NAT/NAPT configuration"
on page 122 provides a general overview of the network address
port translation and describes the tasks involved in its configuration.
•
Chapter 12,
"Ethernet port configuration"
on page 131 provides an overview of Ethernet ports and
describes the tasks involved in their configuration through SmartWare.
•
Chapter 13,
"Link scheduler configuration"
on page 141 describes how to use and configure SmartWare
quality of service (QoS) features.
•
Chapter 14,
"Serial port configuration"
on page 160 provides an overview of the serial port and describes
the tasks involved in its configuration through SmartWare.
•
Chapter 15,
"T1/E1 port configuration"
on page 179 provides an overview of the T1/E1 ports, their char-
acteristics and the tasks involved in the configuration.
•
Chapter 16,
"Basic IP routing configuration"
on page 189 provides an overview of IP routing and describes
the tasks involved in configuring static IP routing in SmartWare.
•
Chapter 17,
"RIP configuration"
on page 196 provides an overview of the routing information protocol
(RIP) and describes the tasks involved in configuring RIP features within SmartWare.
•
Chapter 18,
"Access control list configuration"
on page 206 provides an overview of IP access control lists
and describes the tasks involved in their configuration through SmartWare.
•
Chapter 19,
"SNMP configuration"
on page 220 on page 238 provides overview information about the
simple network management protocol (SNMP) and describes the tasks used to configure those of its features
supported by SmartWare.
