![background image](http://html1.mh-extra.com/html/patton-electronics/smartware-r-3-20/smartware-r-3-20_software-configuration-manual_4044387365.webp)
H.323 interface configuration task list
365
SmartWare Software Configuration Guide
31 • H.323 interface configuration
Mode:
Interface H.323
Example:
Enable CLIP/CLIR support
The following example shows how to enable CLIP/CLIR support on the H.323 interface MyH323If.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#clip-clir-support
Enabling ‘early-proceeding’ on H.323 interfaces
The
early-proceeding
command can enable the early-proceeding feature on H.323. If this feature is enabled,
the gateway will immediately reply with an H.225 (H.323) call-proceeding message in response to a received
H.225 (H.323) setup message without waiting for a response from the destination.
Mode:
interface h323 <if-h323>
Example:
Enable early call disconnect
The following example shows how to enable early call disconnect on an H.323 interface named MyH323If.
node>enable
node#configure
node(cfg)#context cs
node(ctx-cs)[switch]#interface h323 MyH323If
node(if-h323)[MyH323If]#early-disconnect
Enabling the early call disconnect (optional)
Early call disconnect suppresses busy tones (e.g. disturbing a telephone conference) and post-call announce-
ments by sending an H.323 Release message to the remote peer when the connected terminal hangs up (ISDN:
when Disconnect message is received; analog line: when busy tone is detected, loop current is interrupted, or
battery voltage is reversed).
Procedure:
To enable early call disconnect
Mode:
Interface H.323
Step
Command
Purpose
1
node(if- h323)[if-name]#clip-clir-support
Enables CLIP/CLIR support on the H.323
interface
Step
Command
Purpose
1
[
name
](if-h323)[
if-name
]#early-proceeding
Enables the early-proceeding feature.
Step
Command
Purpose
1
node(if-h323)[
if-name
]#early-disconnect
Enables early call disconnect (Default: dis-
abled)