6. Connection
WMD078TE0PAA07
47
3) What this remote controller can do
4) Error display
5) Other messages
●
Switching control processs
・
NO CRATER ...........MAIN
・
CRATER .................MAIN and CRATER
・
INI.&CRATER .........INITIAL, MAIN and CRATER
・
ARC SPOT..............ARC SPOT
●
Setting welding voltage at arc spot
•UNITARY
...............Arc spot voltage, Voltage fine adjustment value, Arc spot time
•INDIVIDUAL
...........Arc spot voltage, Arc spot time
●
Setting welding current, wire feed rate and thickness
●
INCHING operation
●
Pulse setting
●
Various functions
1. CH CALL..................................Call CH data to play, display comment
2. CH RECORD ............................Save/delete CH data
3. SETTING..................................Adjusting waveform control and wire feed rate
4. UNITARY/INDIVIDUAL ............Voltage at Unitary/individual setting
5. GAS-CHECK.............................Perform/terminate gas check function
6. Pulse setting............................Whether to use pulse
7. WELD CONDITION ..................Display weld conditions displayed on the panel of
the welding power source
E R R 0 0 1
Displays the error number and content in case of an error.
E . S T O P
N O W
L O C K E D
While “LOCK” is applied on the welding power source, the
remote controller cannot be used.
C A N
N O T
U S E D
While performing “Select or “Set”functions on the weld
-
ing power source, the remote controller cannot be used.
It is to avoid possible discrepancy in panel display between
the remote controller and the welding power source.
O P E
P A N E L
I N
O P E R A T I O N
W E L D
T A B L E
The messages may be displayed when welding conditions
were changed using the panel on the welding power
source.
C H E C K I N G
T H E R E
I S
N O
W E L D I N G
D A T A
