Settings and Printing
Network
Network
Maintenance and Spec.
Setup in Windows
11
■
Using the Network Setup Tool
If the administrator manages the IP Address, contact him/her to confirm the values before the
installation. If not, set the unique value that is not used by another device on the network. Refer to the
example shown below.
Example
(assigning the IP Address, Subnet Mask and Default Gateway)
IP Address:
172.16.x.x
(x: you can choose any number from 0-255 except 0.0 and 255.255)
Be sure that the IP Address is not assigned to the other devices.
Subnet Mask:
255.255.0.0
It is the same value for all devices.
Default Gateway:
Not required. (0.0.0.0 or set to same as other devices on the network)
NOTE:
• 0 should not be used at the initial value of IP Address. For example, if the IP Address is 5, enter the
number 5 (05 or 005 is incorrect). If there are any 0’s, 0 is OK, but 00 or 000 is incorrect.
First install the Network Setup Tool by using the printer CD-ROM disk and then set up TCP/IP on the
printer.
If the Network Setup Tool is already installed, click
[Start]
, move the pointer to
Programs
or
All
Programs
,
Panasonic
and
Panasonic DP-CL21P
or
Panasonic DP-CL21M
, then click
Network
Setup Tool
.
Proceed to the step 6.
1
Insert the printer CD-ROM disk into the CD-ROM drive.
The CD-ROM launches automatically.
NOTE:
• If the CD-ROM does not launch automatically, perform the following steps.
(1) Double click
My computer
icon (Windows XP:
start
-
My Computer
).
(2) Double click the CD-ROM icon.
