Panasonic WJ-SX 150A, Operating Instructions Manual

Page: 177 / 220

5
■
Program Preset Position
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. To move the camera to the position to be preset, move
the 3D joystick and press the lens control buttons.
3. To select the desired preset position number, press the
numeric buttons. (1 to 64)
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
5. Press the PRESET/PGM PRESET button while holding
down the SHIFT button to save a preset position of the
selected camera.
Notes:
• If the entered position number has stored the previ-
ous preset position, it will be overwritten by the new
one.
• SETUP MENU and WJ-SX150A Administrator
Console can configure each operator's pan/tilt con-
trol. (Refer to the operating instructions of matrix
switcher.)
■
Call Preset Position
1. Select the desired monitor and camera. (Refer to p. 3
Monitor Selection and p. 3 Camera Selection.)
2. To select the desired preset position number, press the
numeric buttons. (1 to 64)
3. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
4. Press the PRESET/PGM PRESET button to move to the
preset position of the selected camera on the active
monitor.
Notes:
• To use the above function, you must set the preset
position number for the camera.
• If you press no numeric buttons or the button 0 in
Step 2, the camera will move to the home position.
Mon1 Cam03 Pre48
Memory
Mon1 Cam03 Pre05