C A U TI O N
n
COM Port of Barcode Module is occupied during reading barcode by Barcode Key Emulator. When reading barcode by Barcode Key
Emulator is not necessary, touch [Connection to Barcode (Always-On)] in [2D Barcode Key Emulator].
N O T E
n
When the barcode read operation is finished, please wait about three seconds to start the next reading. You may press the button imme-
diately, even if you set to release, it takes several seconds to light to light actually.
n
If an error message appears and nothing is displayed, restart this utility.
n
To disable the automatic rotation of the screen when reading the barcode, press the
.
n
When the computer has resumed from sleep and hibernation, an error may appear and the connection with this utility may be lost. If
this occurs, perform step 1.
To Correctly Read a Barcode with This Computer, Observe the Following
The reading angle is important factor.
Perform reading at the angle indicated in the figure. We recommend you to set at approximately 2° to 3° angle from the perpendicular position.
Hold the reader farther away when reading a larger barcode, and closer in when reading a smaller barcode.
Perform reading so that the entire symbol falls within the center of the red Barcode Reader light. The reader can still read a barcode
even if the barcode is not in the center of the red Barcode Reader light.
However, if a part of the barcode lies outside the Barcode Reader light, the barcode cannot be read. Make sure the entire barcode is
inside the Barcode Reader light.
Correct
Incorrect
C.
Barcode Reader Light
-
88
-
