![background image](http://html.mh-extra.com/html/panasonic/fz-g1-series/fz-g1-series_operating-instructions-reference-manual_264483078.webp)
<When performing “Battery Recalibration” after shutting down Windows>
Full charge: Approximately 3.5 hours (with FZ-VZSU84A series) / Approximately 3.5 hours (with FZ-VZSU88U)
Complete discharge: Approximately 3.0 hours (with FZ-VZSU84A series) / Approximately 7.0 hours (with FZ-VZSU88U)
When performing “Battery Recalibration” without shutting down Windows, it may take more time to charge / discharge.
Battery duration
Note that the computer consumes electricity even when the computer power is off. If the battery pack is fully charged, the battery will fully discharge in the
following period of time:
Status
Discharge period
FZ-VZSU84A series
FZ-VZSU88U
When power is off
Approx. 7 weeks
Approx. 14 weeks
In sleep
Approx. 10 days
Approx. 20 days
In hibernation
Approx. 7 weeks
Approx. 14 weeks
The battery duration while the USB port continuous charging function is not used.
The above value is the holding time at room temperature.
When the battery indicator does not light on
The battery indicator may not light on even if the AC adaptor and the battery pack are correctly connected to the computer, due to the following reasons.
The AC adaptor’s protection function may be working. In this case, pull out the AC cord and wait for more than 1 minute before reconnecting the
AC cord.
Sensors
This computer is equipped with four sensors (acceleration sensor, gyro sensor, magnetic sensor, ambient light sensor), and you can use these sensors
with any software that is compatible.
As the accuracy of each sensor output is dependent on the operating environment and other conditions, the results should only be used as a reference.
The acceleration sensor, gyro sensor, and magnetic sensor are located at the bottom left of the LCD. The detection results of each sensor may vary
depending on how you are holding the computer, the application software you are using, and other factors.
Automatic brightness adjustment
The computer is equipped with an automatic brightness adjustment function that adjusts the display screen based on the ambient light sensor. You can
configure the automatic adjustment function as follows.
1.
Touch
(Start) -
(Settings) - [System] - [Display].
2.
Add the check mark to [Change brightness automatically when lighting changes] under “Brightness and color”.
C A U TI O N
n
The [Change brightness automatically when lighting changes] item may not be available in some cases. In such cases, touch the arrow to the left
of [Settings] at the top left of the screen, and perform the operation from [System] - [Display] again.
The ambient light sensor is located at the top of LCD.
The ambient light cannot be detected properly if this area is obstructed or dirty.
Magnetic sensor
The magnetic sensor on the computer operates by detecting geomagnetism. Therefore, the magnetic sensor may not function properly and it readings
may be inaccurate, especially in the following environments.
Inside or near steel structures such as buildings or bridges
Inside or near automobiles, or near train power lines
Near metallic furniture or appliances
-
78
-