Sound
No sound.
Press
/
to cancel mute.
Turn off the concealed mode. (
)
Restart the computer.
Beeping sounds are not emitted by this device.
Distorted sound.
Stop and restart playback.
Cannot record with microphone
Use a monaural condenser microphone.
Cannot change the volume by pressing
/
.
Activate the Windows sound function. When it is not active, the volume does not change even if
slide bar is displayed.
The microphone volume is small.
Increase the volume of the microphone according to the following steps.:
1.
Touch
(Start) - [Windows System] - [Control Panel].
2.
Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then increase the volume of [Microphone Array] and/or [Microphone
Boost] in [Levels].
When signing in (e.g., resuming the com-
puter), audio is distorted.
Perform the following steps to change the audio settings to prevent audio output.
1.
Touch and hold
(Speaker) on the task tray, and touch [Sounds].
2.
Remove the check mark from [Play Windows Startup sound].
The feedback noise may occur.
To stop microphone's monitoring output.
1.
Touch
(Start) - [Windows System] - [Control Panel].
2.
Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then remove a check mark for [Listen to this device] in [Listen].
Input Characters
Cannot enter special characters (ß, à, ç,
etc.) and symbols.
Use the character map.
1.
Touch
(Start) - [Windows Accessories] - [Character Map].
2.
Input “Character”.
Network
<Only for model with LAN>
Cannot connect to a network.
Set the device
to [Enabled] in the [Advanced] menu of the Setup Utility.
<Only when using the Cradle with LAN>
Cannot connect to a network.
Set
to [Enabled] in the [Advanced] menu of the Setup Utility.
-
113
-
