Panasonic AV-HS60C3G, Operating Manual

Page: 57 / 176

– 57 –
Chapter 5 Basic Operations — Wipe
- SQ: 42, 43, 44, 45
1
Select the <ME1>/<ME2> button → [BKGD] → [Modify] tab.
2
Select [H Modulation] and [V Modulation] in the R menu, and set [Amplitude], [Frequency], and [Speed] in the encoder menu.
[Amplitude] Sets the amplitude of the wave.
[Frequency] Sets the frequency of the wave.
[Speed] Sets the speed of the wave movement.
3
Select the items in [H Pattern] and [V Pattern] in the [Modulation] column.
[Sine] Selects sine waves.
[Delta] Selects delta wave.
Setting the transition MID Position
Adjusts the position and size of the pattern waveform when the transition amount is in the range of 40% to 60% (mid position).
f
Enabled when the following pattern waveforms are selected.
- SQ: 51, 52, 53, 54
1
Select the <ME1>/<ME2> button
→
[BKGD]
→
[Position] tab.
2
Select [MID Position] in the R menu, and display the encoder menu.
3
Set [X] and [Y] in the encoder menu.
Sets the position of the pattern waveform.
f
SQ: 51 will place two sub-screens symmetrical to the Y axis.
f
SQ: 52 will place two sub-screens symmetrical to the X axis.
f
SQ: 53 will place two sub-screens symmetrical to the center point.
4
Set [Size] in the encoder menu.
Sets the size of the pattern waveform.
Setting the transition start position
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select [Pos/Size] in the R menu, and set [X], [Y], and [Size] in the encoder menu.
Setting the transition mid position
1
Select the <ME1>/<ME2> button
→
[BKGD]
→
[Position] tab.
2
Select [MID Position] in the R menu, and set [X], [Y], and [Size] in the encoder menu.
3
Select the [Transition] tab.
4
Select [Margin Adjust] in the R menu, and set [Mid Margin] in the encoder menu.
f
Set the mid area.
Setting spin effects
1
Select the <ME1>/<ME2> button → [BKGD] → [Position] tab.
2
Select the items in the [Spin Mode] column.
[Off] Does not spin regardless of setting value of [X-Spin], [Y-Spin], and [Z-Spin].
[Trans Spin] The spin will be at the specified spin amount between the mid position and the end point.
[Auto Spin]* The behavior will be the same as [Manual Spin], irrespective of the [Spin] setting in the R menu.
[Manual Spin]* Tilts in specified amount of spin regardless of the transition.
* It may become discontinuous at the edge of transition in the [Auto Spin] or [Manual Spin] modes.
3
Select [Spin] in the R menu, and set [X-Spin], [Y-Spin], and [Z-Spin] in the encoder menu.
f
This sets the amount of rotation of the spin effect during background transition.
@ @ NOTE
t
Adjust to an angle so that you cannot see side surfaces other than the added side surface.