Panasonic AV-HS60C3G, Operating Manual

Page: 21 / 176

– 21 –
Chapter 3 Part Names and Functions — ME Unit AV-LSM10
ME Unit AV-LSM10
Rear panel
$&,1 $&,1
5))
$
6)3 6',,1 6',287
%
&
/$1 /$1
1 <REF> terminals (connector: BNC
×
2/signal: Genlock)
Loop-through output is performed in external sync mode. If loop-through output is not going to be used, provide a 75 Ω termination.
Black burst signals are output from both terminals in the internal sync mode.
Not used on this unit. Do not connect a cable.
2 <SFP28 1> - <SFP28 4> terminals (connector: SFP28
×
4)
Used for LPS-Link connections between units. Connect according to the system connection plan.
Use SFP28-SFP28 direct attach cables for LPS-Link cables.
3 <SDI IN 1>, <SDI IN 2 > terminals (connector: BNC × 2/signal: SDI IN)
Not used on this unit. Do not connect a cable.
4 <SDI OUT 1>, <SDI OUT 2 > terminals (connector: BNC × 2/signal: SDI OUT)
Not used on this unit. Do not connect a cable.
5 <LAN1> terminal (connector: RJ-45/signal: 1000BASE-T)
Used to connect the units in the switcher system or the control panel.
Use a GbE hub, etc., and connect all of the units according to the system connection plan.
6 <LAN2> terminal (connector: RJ-45)
For a future expansion feature. Do not connect a cable.
7 <AC IN 1>, <AC IN 2> terminals (signal: AC)
Connect the supplied AC Cables and insert each into an AC outlet. (AC100 V to 240 V, 50 Hz/60 Hz)
f
The supplied AC Cables have 3-pin plugs with grounding terminals. Plug into 3-pin outlets equipped with grounding terminals.
f
If you are unable to use 3-pin outlets, be sure to contact the place of purchase.
@ @ NOTE
t
The shielded cables to be connected to the <LAN> terminals should conform to 1000BASE-T.
t
The cables to be connected to the <SFP28> terminals should be suitable for 25 Gbps transfer.