Palfinger 200010121, Manual

Page: 45 / 435

42
Installing and connecting the platform
9 Installing and connecting the platform
If you have installed your PALFINGER Tail Lifts tail lift with
premounted platform (see chapter 7.2 onpage 33), you can skip the
first three steps in platform installation and begin with step
„Adjusting the tilt cylinder“ on page 47.
The following steps are required:
• bring up the platform with the lifting equipment and position
it (see chapter 9.1 on page 42)
• bolt the platform to the control rod (see chapter 9.2 on page 43),
• bolt the platform to the first tilt cylinder (see chapter 9.3
on page 44),
• adjust the tilt cylinder (see chapter 9.4 on page 47),
• bolt the platform to the second tilt cylinder (see chapter 9.5
on page 48)
• connect plug for foot-operated switch and Warnfix (see
chapter 9.6 on page 48),
• install tilt sensor (see chapter 9.7 on page 49).
9.1 Moving up and positioning platform
This step is only required if you have installed your
PALFINGER Tail Lifts tail lift with the supplied installation aids
(see chapter 7.1 on page 24).

Raise the platform with a suitable lifting equipment, e.g. a forklift
truck and bring the platform up to the truck tailgate.