Palfinger 200010121, Manual

Page: 183 / 435

116
Programming a Key Code

You can switch on the tail lift by a key code. The factory set-
ting is:
To change this key code:

Open the platform.

Bring down the platform until it is adjusted flush to the
ground.

Open the sealing cap of the support tube (on the right, as
seen in direction of travel) or open the cover of the hydraulic
unit.

Disconnect plug J 30.

Switch off the electrical equipment.

Connect the contacts J 30/5, 6, 14, 3 with contact 4 (service
plug).

Switch on the electrical equipment.
The tail lift is now in programming mode.

Disconnect the service plug and connect plug J 30 at the
lateral operating element.

Enter the desired code at the lateral operating element as
follows:
Each key actuation switches on the warning lights.
If your entry has been correct, the programming mode is
automatically left. You can continue to operate your tail lift
as usual.
If your entry was faulty, the warning lights briefly flash 5
times. You have to enter the code again.
A
Key (Combination) to be Pressed
Lift Close Lift
3 x 3 x 3 x
Key (Combination) to be Pressed
Lift Close Lift
x-times x-times x-times