Palfinger 200010121, Manual

Page: 273 / 435

22
Presetting the Tail Lift
This chapter provides principle settings to enable the comfort-
able and safe use of the tail lift.
Setting the Ground Adjustment Timing
Only for E-Type equipment with lift arms switch b13 the work-
shop can determine the time the platform initiates the tilt pro-
cess (ground adjustment) after making contact with the ground.
To adjust the timing for the ground adjustment:

Loosen the fastening screw at lift arms switch b13 ( 6 ).

To set an „ earlier “ ground adjustment, turn lift arms switch
b13 ( 6 ) a few millimeters clockwise.
To set a „ later “ ground adjustment, turn lift arms switch b13
( 6) a few millimeters counterclockwise.

Retighten the fastening screw at lift arms switch b13 ( 6 ).

Check whether the platform initiates the tilt process at the
time desired.

Check whether the spring washer is mounted between lift
arms switch and screw and fold back the locking plate.
The time the platform is supposed to tilt has been preset
now. The platform tilts earlier or later.
Presetting the Platform Tilt
After the platform was lifted from the ground, it reverts to the
preset position. You can adjust the tilt of the platform slightly
higher or lower.

Adjust the desired upper position using the “Open/Close”
pushbuttons of the operating panel (see chapter “Operating
Elements” from p. 38). This is only possible with the tilt sen-
sor b15 on the platform.
A C F
6
HORIZONTAL
250
mm
A E F G K