Painless Performance Products 10106, Installation Instructions Manual

Page: 8 / 45

Figure 3.1 Contents of the Painless Wire Harness Kit
* 10105 does not come with the Turn Signal Switch Connector.
4.0 TOOLS NEEDED
In addition to your regular tools, you will need, at least, the following tools:
Crimping Tool (
Note: Use a quality tool to avoid over-crimping)
Wire Stripper
Continuity Tester (test light or ohm meter)
Electric Drill
1 ¼” Hole Saw
Small (10 amp or less) Battery Charger
5.0 PRE-INSTALLATION AND GENERAL GUIDELINES
The installation of your wire harness mainly consists in two parts:
▪ The physical routing and securing of the wire harness, wires and groups.
▪ The proper connection of the individual circuits.
These two major tasks are not separate steps, but are integrated together. That is, you will route
some wires and make some connections, route some more wire and make some more
connections.
We cannot tell you how to physically route the harness in your Jeep. Because of possible
modifications to your Jeep, we do offer some routing practices starting in Section 5.1, physical
installation instructions in Section 6.0, and precise instructions concerning the electrical
connections you will have to make beginning in Section 7.0. To help you begin thinking through
the installation of your wire harness, read the following sections:
3