Painless Performance Products 10106, Installation Instructions Manual, Page: 22 / 45

8.1.2 Generator to Alternator Conversion
A. You can convert your generator charging system to use an alternator
and external regulator without altering or re-routing existing wires. You
will need to obtain an externally regulated alternator and a compatible
voltage regulator.
B. Install the new alternator and replace the existing generator voltage
regulator with the new, alternator-compatible one.
C. Connect the existing wiring according to either Section 8.0, 9.0, 10.0,
or 11.0, as appropriate.
8.1.3 Motorola Alternator Charging System. See Figure 8.2.
A. Locate the Alternator Voltage Regulator. It may not appear exactly as
represented.
B. Find the one wire that connects from the Voltage Regulator to the
Starter Relay. Disconnect this wire from the Relay and splice it to wire
#714 (wht). LEAVE THE REMAINING VOLTAGE REGULATOR WIRES
INTACT in their original configuration. You may replace them, ONE AT A
TIME, and incorporate them into the new harness, if you wish.
C.
Connect the provided 6 gauge red wire to the Alternator Battery/Output
terminal.
Figure 8.2 Motorola Charging System
17