User’s Manual
36
You can assign IDs to each camera by highlighting the box under the
ID
heading and pressing the button.
Change the number by highlighting it and using the
Up
and
Down
arrow buttons to increase and decrease
the number. The PTZ ID number can be set from 0 to 256.
Highlight the box beside
PTZ Port
and press the button to select the port to communicate with PTZ
cameras.
Highlight
Setup…
and press the button. The Port Setup screen appears.
After you are finished with the Camera Screen, you can highlight
Save
and press the button to save
the changes and exit the screen. If you do not wish to save the changes, highlight
Cancel
and press the
button to exit the screen.
Audio Setup (DEVICE
Audio Tab)
Figure 28
─
Audio screen.
The DVR can record up to four audio inputs. Highlight the box beside the input and press the button.
A list of cameras appears, and you can select which camera you want associated with that audio input.
Highlight
Enable Audio-Out
and press the button. This toggles between enabling and disabling audio out.
After you are finished with the Audio Screen, you can highlight
Save
and press the button to save the
changes and exit the screen. If you do not wish to save the changes, highlight
Cancel
and press the
button to exit the screen.
Select your camera from the list and press the button. You will need to connect
the camera to the RS232 or RS485 connector on the back of the DVR following
the camera manufacturer’s instructions.
Configure the port’s setting based on the PTZ camera manufacturer’s
instructions.