Oval Ultra mass MKII CN003, Instructions Manual

Page: 38 / 72

L-718-8-E
Item Terminal Label Description Remarks
1 PULSE ＋
Pulse output
2 PULSE －
3 S OUT ＋
Status output, open collector output
4 S OUT －
Normal: ON, Error: OFF
5 S IN
Status input (Form "a" contact input)
6 S IN COM
7 ANALOG 2 ＋ Analog output 2
8 ANALOG 2 －
9 ANALOG 1 ＋ Analog output 1
10 ANALOG 1 －
11 D. GAIN ＋
Drive control voltage output (for testing)
12 D. GAIN －
LINE/ ＋ Power (DC power source: ＋)
GND Grade "D" earth ground
NEUT/ － Power (DC power source: －)
EARTH Grade "A" earth ground
NOTE: If pulse output is of voltage pulse output specification, analog output 2 is not available.
Never make wiring connections. (See Section 7.6.)
CAUTION: Do not forget to earth ground GND or EARTH terminal.
Failure to follow this instruction may cause a loss of meter error.
Be sure to earth ground
GND or EARTH terminal.
① For output wiring, use
shielded, twisted pair
AWG 24 to 16.
② Maximum load resistance
for analog output 1 and 2
is 600Ω
③ Transmission lengths with
frequency output ( voltage
pulse) are
10 meters max. at 10kHz
100 meters max. at 1kHz
1 kilometer max. at 100Hz
5.7 Output Signal and Power Terminal Identification
O
ut
pu
t S
ig
na
l
Po
we
r
Term.No.
Label Description Remarks
(cable color)
BLK SHIELD
Bundle shield wire of bwn/red, grn/wht, blu/gry,
org/pur/yel lines.
BWN ( ＋ ) DRIVE
Flow tube drive output
RED ( － ) DRIVE
ORG TEMP B Temperature input
YEL TEMP b Temperature input
GRN ( ＋ ) LPO Left position pickoff sensor input
BLU ( ＋ ) RPO Right position pickoff sensor input
PUR TEMP A Temperature input
GRY ( － ) RPO Right position pickoff sensor input
WHT ( － ) LPO Left position pickoff sensor input
5.8 Separately-mounted Sensor and Separately-mounted Transmitter
(preamplifier) Terminal Identification
Using exclusive
interconnect cable,
the transmission
lenght is 200 meters
max.
Se
ns
or U
ni
t t
o T
ra
ns
mi
tte
r