Link Aggregation Control Protocol (LACP) Cannot Be Used In Certain Conditions
#
echo 1 > 0000\:08\:00.0/power
10. To verify that the slot is powered up, issue the
ls
command.
#
ls
0000:08:00.0
0000:08:00.1
The hot plug procedure is completed without a system hang.
As an alternative, you can also use the Attention button to perform hot plug/hot unplug
operations as follows:
■
To perform a hot unplug operation – Press the Attention button on the HBA and wait. The
OK LED will blink for 5 seconds, and then remain off.
■
To perform a hot plug operation – Press the Attention button on the HBA and wait. The OK
LED will blink for 5 seconds, and and then remain on.
In the event you would like to cancel an Attentionn button hot plug/hot unplug operation, press
the Attention button again, after pressing the button to initiate the operation.
Link Aggregation Control Protocol (LACP) Cannot Be Used
In Certain Conditions
Bug 18707752
Conditions:
■
System Platform: All supported systems using the Oracle Solaris driver
■
Operating Protocol Mode of HBA: FC, CNA
■
Environment: HBA connected directly to supported storage
Issue:
LACP cannot be used on the same port as FCoE or iSCSI.
Workaround:
None.
Chapter 4 • Known Issues
43
Summary of Contents for 7101690
Page 2: ......
