Installing Drivers
■
During boot up, the OneCommand Manager CLI clears the flash region upon successful
dump capture.
■
If the failure occurs on the HBA, and the OneCommand Manager CLI is already installed,
the OneCommand Manager CLI captures collect firmware dumps and automatically clears
the flash region.
■
If the failure case did not capture the dump file, or if the OneCommand Manager CLI is not
running, you can manually run the OneCommand Manager CLI to collect the dump file.
Installing Drivers
This section contains the following topics:
■
“Installing Drivers for the Oracle Solaris OS” on page 39
■
“Installing Drivers for All Other Supported Operating Systems” on page 39
Installing Drivers for the Oracle Solaris OS
Before using the HBA, update the HBA driver software for the Oracle Solaris OS with the
following SRU version or patches, at minimum:
■
Oracle Solaris 11.1 OS for the SPARC and x86 platforms - SRU13.4
■
Oracle Solaris 10 1/13 OS for the SPARC platform - Patches 149167-07 and 149175-11
■
Oracle Solaris 10 1/13 OS for the x86 platform - Patches 149168-07 and 149176-11
The latest available SRU versions and patches are located at:
Before downloading any SRUs, install the utilities and then the firmware, in that order, for the
HBA. You can then download and install the latest SRUs from this web site:
.
Installing Drivers for All Other Supported
Operating Systems
If drivers for specific operating systems are required by the HBA, the drivers will be available
for download at the Emulex (now Broadcom) support site for Oracle. Before installing
any drivers, install the utilities and then the firmware, in that order, for the HBA. For more
Chapter 3 • Software Installation
39
Summary of Contents for 7101690
Page 2: ......
