To Configure the HBA (Oracle Solaris)
If the HBA is properly installed and connected, you will see output similar to the following:
cfgadm
Ap_Id Type Receptacle Occupant Condition
c3 fc connected configured ok
c4 fc connected configured ok
pcie5 fibre/hp connected configured ok
To Configure the HBA (Oracle Solaris)
If the HBA is shown as unconfigured or disconnected, use the
cfgadm
‐
c
configure
command to configure the HBA.
To Verify Attached Storage (Oracle Solaris)
Use the
cfgadm -al
command to verify attached storage.
If the HBA is properly installed and storage is connected properly, you will see output similar to
the following example. In this example, one port of a HBA is connected through a fabric switch
to two ports of a disk array.
cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c3 fc-fabric connected configured unknown
c3::200600a0b816005e disk connected configured unknown
c3::200700a0b816005e disk connected configured unknown
c4 fc connected unconfigured unknown
pcie5 fibre/hp connected configured ok
If the HBA is shown as unconfigured or disconnected, see
Chapter 2 • HBA Installation, Configuration, and Removal
27
Summary of Contents for 7101690
Page 2: ......
