54
Section 3
Switch Settings
RFID System
Operation Manual
Section 3
Preparing Communications
■
SW4 Pin 1: Priority Mode Switch
■
SW4 Pin 2: Verify Setting
■
SW4 Pin 3: Seven-segment Display Switch
■
SW4 Pin 4: Lower Trigger Execution Switch
■
SW4 Pins 5, 7, and 10: Reserved.
Do not change the settings of these pins. Leave them set to OFF.
■
SW4 Pin 6: Test Switch
Note: This switch is effective only in MAINTENANCE mode.
■
SW4 Pin 8: TEST Head Specification
Note: This switch is effective only in MAINTENANCE mode.
■
SW4 Pin 9: TEST Command Specification
Note: This switch is effective only in MAINTENANCE mode.
SW4 pin 1
Description
OFF
Communications Distance Priority Mode
ON
Communications Time Priority Mode
SW4 pin 2
Description
OFF
Verification enabled.
ON
Verification disabled.
SW4 pin 3
Description
OFF
End code display
ON
I/O display
SW4 pin 4
Description
OFF
Disabled.
ON
Enable (rising edge)
SW4 pin 6
Description
OFF
Test stopped.
ON
Test executed.
SW4 pin 8
Description
OFF
Communicate with Read/Write Head 1.
ON
Communicate with Read/Write Head 2.
SW4 pin 9
Description
OFF
Use read test.
ON
Use write test.
Summary of Contents for V600 Series
Page 50: ...48 Section 2 Wiring RFID System Operation Manual Section 2 Installation and Wiring MEMO ...
Page 72: ...70 Section 4 Write Command Memory RFID System Operation Manual Section 4 Function ...
Page 138: ...136 Section 5 End Codes RFID System Operation Manual Section 5 Communications MEMO ...