47
RFID System
Operation Manual
Sect
ion 2
Wiring
Section 2
Installation and Wiring
Read/Write Head Connection Port
■
Inserting and Removing the Connector
1.
Hold the rubber mold of the connector and insert the connector into
the mating connector on the ID Controller.
2.
Push the connector straight in until it is locked.
The connector will not lock if it is pushed while holding the ring. Be sure to
hold the rubber mold.
3.
To remove the connector, pull it straight out while holding the ring.
The connector must not be pulled while holding the rubber mold.
If an excessive force is applied to the cable, the cable may break or be dam-
aged.
Ring
Rubber mold
Ring
Summary of Contents for V600 Series
Page 50: ...48 Section 2 Wiring RFID System Operation Manual Section 2 Installation and Wiring MEMO ...
Page 72: ...70 Section 4 Write Command Memory RFID System Operation Manual Section 4 Function ...
Page 138: ...136 Section 5 End Codes RFID System Operation Manual Section 5 Communications MEMO ...