![background image](http://html.mh-extra.com/html/omron/v600-series/v600-series_user-manual_743003024.webp)
22
Sec
tion 2
In
st
al
la
ti
on
RFID System
Operation Manual
Section 2
Installation and Wiring
Installation
Observe the following precautions when installing the V600-CA5D01 or V600-CA5D02 ID Controller to enable
proper performance of all functions.
Installation Environment
Do not install the ID Controller in the following locations.
• Locations where the ambient operating temperature is not between
10 and 55
C or locations where
condensation may occur as the result of rapid variations in temperature
• Locations where the ambient operating humidity is not between 35% and 85%
• Locations subject to corrosive gases, inflammable gases, dust, dirt, metal powder, or salt
• Locations subject to direct vibration or shock
• Locations subject to direct sunlight
• Locations subject to contact with water, oil, or chemicals
• Location over 2,000 m above sea level
Mounting Position in a Control Panel
The operating temperature range of the ID Controller is from
10 to 55
C. When installing the ID
Controller in a control panel, pay attention to the following points:
• Provide enough space around the Controller for ventilation.
• Do not install the ID Controller in the vicinity of equipment generating heat (such as heaters,
transformers, and large resistors).
Installation Methods
■
Mounted in a Panel
When mounting directly to a control panel, always use flat washers and M4 screws.
Recommended tightening torque: 1.2 N·m
95
105
Two, M4
80
90
80
Summary of Contents for V600 Series
Page 50: ...48 Section 2 Wiring RFID System Operation Manual Section 2 Installation and Wiring MEMO ...
Page 72: ...70 Section 4 Write Command Memory RFID System Operation Manual Section 4 Function ...
Page 138: ...136 Section 5 End Codes RFID System Operation Manual Section 5 Communications MEMO ...