Omron PROFINET NX-PNC202, User Manual

Page: 100 / 282

6 Installation
6 - 6
NX-series PROFINET Coupler Unit User’s Manual (W623)
You must install the PROFINET Coupler Unit and NX Units on a DIN Track.
The following products are recommended.
Not all of the combinations of the DIN Tracks and End Plates listed above are possible.
Confirm applicability of the combinations in the following table.
Also, use screws and washers of the following sizes to fix the DIN Tracks.
(a): Dimensions from the screw head to the fastening surface
If you use any DIN Track other than those listed in the table above, refer to the dimensions shown in
6-1-10 Assembled Appearance and Dimensions
on page 6-20 and use proper screws and washers.
6-1-2 Preparations for Installation
Name Model Manufacturer Remarks
35-mm DIN
Track
PFP-50N OMRON Corporation • Length: 50 cm
• Material: Aluminum
• Surface treatment: Insulated
PFP-100N OMRON Corporation • Length: 100 cm
• Material: Aluminum
• Surface treatment: Insulated
NS 35/7,5 PERF Phoenix Contact • Length: 75.5, 95.5, 115.5, or 200 cm
• Material: Steel
• Surface treatment: Conductive
NS 35/15 PERF Phoenix Contact • Length: 75.5, 95.5, 115.5, or 200 cm
• Material: Steel
• Surface treatment: Conductive
End Plate PFP-M OMRON Corporation Two End Plates are required for each
Profinet IO Device Terminal.
CLIPFIX 35 Phoenix Contact Two End Plates are required for each
Profinet IO Device Terminal.
DIN Track model
PFP-M
(OMRON)
CLIPFIX 35
(Phoenix Contact)
PFP-50N Possible. Possible.
PFP-100N Possible. Possible.
NS 35/7,5 PERF Possible. Possible.
NS 35/15 PERF Not possible. Possible.
DIN Track model
Applicable
screw size
(a)
*1
*1. Dimensions in parentheses are for Communications Coupler Units
with lot numbers through December 2014 or for NX Units with
12-mm widths with lot numbers through December 2014.
PFP-50N M4 4.9 mm max.
(4.1 mm max.)
NS35/7,5PERF M6 5.4 mm max.
(4.6 mm max.)
NS35/15PERF M6 10 mm max.
(a)