Omron NJ501-5300, Instruction & Reference Manual, Page: 86 / 142

2 G Code
2 - 48 NJ/NY-series G code Instructions Reference Manual (O031)
 An arc is added
When an overcut is detected, the operation stops and an error occurs.
To detect an overcut, set the Overcut operation mode to Overcut detection. For details, refer to the
NJ/NY-series NC Integrated Controller User’s Manual (Cat. No. O030).
Detection of Overcut
Programmed path
Programmed path
Move of
cancel
Move of
cancel
Corrected linear
interpolation operation
Arc added Arc added
Corrected
circular
interpolation
operation
Tool center path Tool center path
Cutter
Compensation
Cutter
Compensation Cutter
Compensation
X
Y
: Path after correction
: Specified path